DO315IP
. The display shows the number “0”. With the knob, you can now select the operating
time in 5-minute intervals (up to max. 180 minutes). Then the display counts down
the duration in minute. Once the time is up, an acoustic signal sounds and the device
automatically goes into standby mode. Notice: during timer operation, you can
change the duration at any time with the arrow keys. With the memory function of the
device, the power stage or temperature settings remain unchanged here.
You can also change to the power stage selection or the temperature stage selection
with the “Function “ button and change the settings there without changing the preset
time.
Once the cooking or warming process is nished, disconnect the mains plug from the
outlet!
Do not place any empty cookware on the ceramic eld. Heating an empty pot or pan
activates the overheating protection and the device turns off.
Do not operate the device if it is damaged in any way or does not function properly.
The use of accessories and spare parts not recommended by the manufacturer may
lead to damage on the device and injuries.
CLEANING AND MAINTENANCE
Pull the power plug prior to cleaning the device. Do not use any caustic cleaning
agents and make sure that no water penetrates the device.
To protect yourself from electric shock, never immerse the device, its cables and the
plug in water or other liquids.
Wipe off the ceramic eld with a damp cloth or use a mild, non-abrasive soap solution.
Wipe off the casing and the operating panel with a soft cloth or a mild detergent.
Do not use any petrol products to not damage the plastic parts and the casing/operating
panel.
Do not use any ammable, acidy or alkaline materials or substances near the device,
as this may reduce the service life of the device and lead to deagration when the
device is turned on.
Make sure that the bottom of the cookware does not scrape across the surface of the
ceramic eld, although a scratched surface does not impair the use of the device.
Make sure that the device was properly cleaned before storing it in a dry place.
TROUBLE SHOOTING:
E01: Electronic control of low voltage.
Self-help: Make sure the appliance is connected to the voltage indicated on the rating
label.
E02: Electronic control of excess voltage
Self-help: Make sure the appliance is connected to the voltage indicated on the rating
label.
E03: Short circuit.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales